Remote Installation; Initial Settings; Identifying The Ip Address - Belkin OmniView SMB Mode D'emploi

Remote Installation

Initial Settings

The following section provides instructions for setting the IP address for the
OmniView SMB Remote IP Device.
Step 1 Identifying the IP Address
Once your IP Device has been connected to your network and is powered
up, a Dynamic Host Configuration Protocol (DHCP) server on your network
will automatically assign the IP Device an IP address, gateway address, and
subnet mask.
To identify the IP address on your network, use the MAC address or unique
device number located on the back of the IP Device. If no DHCP server is found
on your network, the IP Device will boot with the following static IP address:
192.168.2.155.
If you want to connect more than one IP Device to the same network and there is
no DHCP server available, connect each IP Device to your network one at a time
and change the static IP address of each unit before connecting the next unit.
Note: If a DHCP server later becomes available on your network, the IP
Device will take a new IP address from the DHCP server. To keep the
original static IP address, you will need to disable DHCP (see page 19).
UK-15