Mounting The Ip Device (Optional) - Belkin OmniView SMB Mode D'emploi

Hardware Installation
Step 1 Mounting the IP Device (optional)
Note: Before you begin, locate the MAC address and device number on the
bottom of the IP Device. You will need these numbers later in the installation
process, so it is highly recommended that you record these numbers below
before mounting the IP Device to your rack.
1.1 Attach the included mounting bracket to either side of the IP Device.
(Refer to diagram below.)
�� �
1.2 Mount the IP Device to the rear post of your rack.
(Refer to diagram below.)
Note: Mounting screws for the rack are not included. Please use the specified
screws from your rack's manufacturer.
MAC Address Device Number
1
2
3
4
5
6
7
8
9
UK-10