Troubleshooting - Duronic BPM150 Manuel D'utilisation

Problem
No power
Low batteries
Show on the display
Error
message
Symptom
Display is dim or
will not light up.
E1 shows
E2 shows
E3 shows
E10 or E11
shows
E20 shows
E21 shows
EExx,shows on
the display.
Check This
Batteries are
exhausted.
Batteries are inserted
incorrectly.
Batteries are low.
The cuff is not
secure.
The cuff is very
tight
The pressure of the
cuff is excess.
The monitor detected
motion while
measuring.
The measurement
process does not
detect the pulse
signal.
The treatment of the
measurement failed.
A calibration error
occurred.
21
Remedy
Replace with new
batteries.
Insert the batteries
correctly.
Replace with new
batteries
Refasten the
cuff and then
measure again.
Refasten the cuff and
then measure again.
Relax for a moment
and then measure again.
Movement can affect the
measurement.Relax for a
moment and then
measure again.
Loosen the clothing
on the arm and then
measure again.
Relax for a moment
and then measure
again.
Retake the
measurement. If
the problem persists,
contact the retailer or
our customer service
department for
further assistance.
Refer to the warranty for
contact information and
return instructions.