Premises And Safety Notes; Application Range; Safety Standards; Components And Accessories - Aprimatic UNICO Instructions

GB

1. PREMISES AND SAFETY NOTES

1.1 Application range

Snap on radio receiver module for controlling an Aprimatic control unit and
a maximum of another 3 generic devices (with dedicated optional relay
modules). May only be used in combination with Aprimatic control units and
remote controls.
When controlling the various devices of the Aprimatic units, follow the capacity
limits for the contacts indicated in the technical specifications.

1.2 Safety standards

• Carry out the operations as specified by the Manufacturer.
• The installer must check the correct installation and functioning of the
equipment.
• Do NOT use the product for purposes other than those envisaged or use
it improperly.
• Do NOT tamper with or modify the product.
• Only use equipment which is in a good state.
• Do NOT work in areas which are not well-lit or in areas which provide a risk
for the health.
• Do NOT allow people to pass through the work area.
• Do NOT leave the work area unmanned.
• Always disconnect the mains power supply before opening the container.
• The product must only be installed by qualified technical personnel.
The electrical system must comply with the standards applicable in the
country in which it is installed.

2. COMPONENTS AND ACCESSORIES

2.1 Receiver (See Figure 1)
J1 Memory module connector
JP5-8 Output channel selection
jumpers
BZL Buzzer
D1 LED
DLL Delete button
JP1-2 Output functioning logic
selection jumpers
JP3-4 Enabling button row selection
jumpers
WARNING: The RF module is housed in a metal container: do NOT open this
container or tamper with the adjustment trimmer, as this may cause
serious malfunctioning of the equipment.
INSTRUCTIONS
- 10 -
JP9 Aprimatic and other unit
monitoring jumper
RF RF module
CON1 Output/power supply terminal
board
CON2 Aprimatic and other unit
monitoring/receiver/power
supply terminal board