ESAB PT-20AMX Manuel D'instruction page 80

These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the principles of opera-
tion and safe practices for arc welding and cutting equipment, we urge you to read our booklet, "Precautions
and Safe Practices for Arc Welding, Cutting, and Gouging," Form 52-529. Do NOT permit untrained persons to
install, operate, or maintain this equipment. Do NOT attempt to install or operate this equipment until you
have read and fully understand these instructions. If you do not fully understand these instructions, contact
your supplier for further information. Be sure to read the Safety Precautions before installing or operating
this equipment.
This equipment will perform in conformity with the description thereof contained in this manual and accompanying la-
bels and/or inserts when installed, operated, maintained and repaired in accordance with the instructions provided. This
equipment must be checked periodically. Malfunctioning or poorly maintained equipment should not be used. Parts that
are broken, missing, worn, distorted or contaminated should be replaced immediately. Should such repair or replacement
become necessary, the manufacturer recommends that a telephone or written request for service advice be made to the
Authorized Distributor from whom it was purchased.
This equipment or any of its parts should not be altered without the prior written approval of the manufacturer. The user
of this equipment shall have the sole responsibility for any malfunction which results from improper use, faulty mainte-
nance, damage, improper repair or alteration by anyone other than the manufacturer or a service facility designated by the
manufacturer.
Be SURe ThIS INFORMATION ReACheS The OPeRATOR.
YOU CAN GeT exTRA COPIeS ThROUGh YOUR SUPPlIeR.
USeR ReSPONSIBIlITY
80