Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1 . Auto Scale Removal Function
1
For
best cleani n
n g results, w
for des s caling
ste a
a m microwa v
Ru n
n steam pro g
g rams on m y
1) Power up the system, remove the water tank, inject 1000ml of fresh water into the
water tank, adding a pack of descaling agent.
2) Push the tank into the furnace where appropriate.
）
3
In waiting state, press
indicator lighten . "℃" and "MIN" lighten. Default cooking time "10:00" lighten.
Press
repeatedly to change function.
4) Press
repeatedly, when " CLE " indicator lighten t means to enter Scale
R emoval function. "MIN" and defaul
5) Press
to start the program.
6) Stay whole 1 minute after the program has finished, take out the water tank and pour
the water in the tank. Thoroughly clean the water tank.
7) Replace the fresh water, repeat steps 3 to 6.
Note
: the desca
ling process
end, the
entire
12. Patameter Adjustment in setting and cooking process
1) In the setting of the parameters, if the fault of the parameters is found, you can press
to return to a parameter set state. The corresponding parameters can be reset in the
same way as previous step.
2) In the cooking process, you can press
The corresponding parameters can be reset in the same ways as previous step.
T
he
order of parameter adjustment is consistent with the setting state.
3) When finish the adjustment during cooking process, it will confirm automatically 3
seconds later if you don't press
we recomme
end that you
v e oven. Fo
llow the ma n
y computer t
t oday after 2
to enter steam function.
t time " 20:00 " lighten, other icons disappear.
s shall not b
e shut down. If the desc c aling process shut down before the
prog
ram must b
e started fro
GB
use deterge
ent sodium
ufacturer's
0 hours, th
e need for d
It flickers 100,
i ,
om s
tep 3
.
to reset the cooking parameters.
to confirm.
20
citrate,which
instructions
on the pac
escaling.
were randomly
o
kaging.
Publicité
Table des Matières
