Monitor Operation; Wall Mounting; Table Mount - Defender GK300-7M2 Manuel D'utilisation

MONITOR OPERATION

WALL MOUNTING

1. Locate a desired mounting location for the
camera/ doorbell station and fasten the mount
using the included mounting hardware.
- Make sure the mounting location is at an
appropriate level for you to access the
buttons and easily view the LCD screen
ensuring it is close enough to a power source
to be plugged in .
2. Plug the jack of the power adapter into the back
of the monitor (labeled DC15V).
3. Plug the other end of the power adapter into
a power source. (It is recommended to use a surge
protecting power bar or a UPS.)
4. Once the bracket is properly mounted, there are
four slots on the back of the monitor that will fit
easily into the mount. Line up the slots with the
pegs on the monitor and slide monitor downwards.
This will securely lock the monitor into the
mounting bracket.

TABLE MOUNT

1. The monitor is also able to stand up right on a flat
surface using the table stand on the back of the
monitor.
2. Place monitor on a flat level surface.
- Make sure that the flat surface is close to a power
source so it can be plugged in.
3. Pull the bottom side of the stand away from the
monitor.
4. Plug the jack of the power adapter into the back of
the monitor (labeled DC 15V).
5. Plug the other end of the power cable into power
source. (It is recommended to use a surge
protecting power bar or a UPS.)
Modèle # GK300-7M2 Model # GK300-7M2
9