FitEngine JTF-718E-3 Mode D'emploi page 11

Contents
Symbols __________________________________________________________ 12
Signal Words ______________________________________________________ 12
Intended Use ______________________________________________________ 12
Safety Notices _____________________________________________________ 13
Assembling the Training Device _______________________________________ 14
Positioning the Training Device ________________________________________ 15
Inserting Batteries into the Training Computer ____________________________ 16
Functions of the Training Computer ____________________________________ 16
Use _____________________________________________________________ 17
Cleaning and Storage _______________________________________________ 18
Disposal__________________________________________________________ 19
Technical Data ____________________________________________________ 19
Exploded Drawing and Parts List ______________________________________ 20
Items Supplied
• 1 x bicycle frame
• 1 x foot with castors, front
• 1 x foot, rear
• 1 x saddle
• 1 x saddle holder
• 1 x handlebar
• 1 x back pad
• 1 x holder for back pad
• 1 x side handlebar
• 1 x training computer
• 2 x pedal
• Assembly materials (see the list under
the "Assembling the Training Device"
chapter)
• 2 x 1.5 V battery, AAA
• 1 x operating instructions
Check the items supplied for complete-
ness and the components for transport
damage. If you fi nd any damage, do not
use the device but contact our customer
service department.
Remove any fi lms, stickers or transport
protection. Never remove the rating
plate and any possible warnings!
Key numbers are shown as follows: (1)
Picture references are shown as follows:
(Picture A)
Button designations are shown as follows:
ON /OFF
Displays are shown as follows: SPM
At A Glance
(Picture A)
1 Handlebar
2 Training computer
3 Shelf
4 Pulse monitor
5 Saddle
6 Back pad
7 Side handlebar
8 Seat height adjusting screw
9 Locking screw
10 Rear feet
11 Main device
12 Front feet, with castors
13 Pedals
14 Bicycle frame
15 Adjusting knob + / - (torque resistance)
16 Expander bands
EN
11