Table des Matières
Publicité
may significantly increase the exposure level
- t he times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCrIPTIOn (fIg. A)
Your multitool has been designed for light
sanding, sawing and scraping applications.
1. O n/off switch
2. Speed adjustment wheel
3. M ounting point for accessories
4. G rip
5. Allen key
6. A llen key holder
13. C arbon brush cover
ASSEMBLy
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the sanding pad and
the sanding paper (fig. B)
The sanding pad and the sanding paper must be
used for sanding applications.
Mounting
• P lace the machine on a table with the mounting
point (3) facing upwards.
• L oosen the Allen screw (7) using the Allen key (5).
• M ount the sanding pad (9) to the mounting point
(3).
• T ighten the Allen screw (7) using the Allen key (5).
• M ount sanding paper (10) with the required
grain size onto the sanding pad (9). Make sure
that the perforation in the sanding paper (10)
corresponds with the perforation on the sanding
pad (9).
- U se coarse sanding paper (grain 50) for
sanding rough, uneven surfaces.
- U se medium sanding paper (grain 80) for
removing the remaining scratches from the
6
coarse sanding paper.
- U se fine sanding paper (grain 120) for
finishing surfaces.
removing
• P lace the machine on a table with the mounting
point (3) facing upwards.
• R emove the sanding paper (10) from the sanding
pad (9).
• L oosen the Allen screw (7) using the Allen key (5).
• R emove the sanding pad (9) from the mounting
point (3).
• T ighten the Allen screw (7) using the Allen key (5).
Mounting the dust extraction (fig C1 + C2)
The dust extraction piece can be used to connect
the machine to a vacuum cleaner when sanding.
Dust will be extracted and your work area stays
cleaner.
the dust extraction adapter can only be
used in combination with the sanding
pad (9).
To install the dust extraction adapter:
• I f not done yet, remove the accessories from
the machine spindle (3).
• A ssemble the dust extraction parts (15A to
15D) together like shown in (Fig. C1 and C2)
• C lick the adapter to the machine spindle until
it fixes well, make sure the rear fingers (15C)
click into the gaps on the machine housing.
• A dd the felt ring (15E) between the pad and the
adapter for a tight sealing and assemble the
sanding pad like instructed in previous chapter.
• C onnect a vacuum cleaner to the adapter end
(15D).
Mounting and removing the saw blade (fig. B)
The saw blade must be used for sawing applications.
Mounting
• P lace the machine on a table with the mounting
point (3) facing upwards.
• L oosen the Allen screw (7) using the Allen key (5).
• R emove the spacer (8).
• M ount the saw blade (11) to the mounting point
(3).
• M ount the spacer (8).
• T ighten the Allen screw (7) using the Allen key (5).
Publicité
Table des Matières
