Activating Priority Mode; Backlight; Fm-Am Switching; Other Important Functions - Albrecht AE 86 H Mode D'emploi

Activating Priority Mode

•
First store one or more frequencies into memory on memory locations P1 .....P5
•
Press F + PRI
•
In the display appears PRI
To deactivate the PRI mode, repeat the same procedure. In that case PRI will disappear from display.
If you start now the scanning process, the radio will also check the PRI channels P1..P5 with a higher
priority (more often) than the other channels 1.....200. Channels P1...P5 are inserted (and repeated)
into the scanning process at least every 2 seconds.

Backlight

•
For using the illumination, press the lamp button.
•
The display will stay illuminated for about 15 seconds.

FM-AM switching

In the AIR band and the other VHF bands the switching between FM, AM and WFM modulation
modes works automatically, because each band is internationally associated with only one possible
modulation mode.
In the CB 10 band both modulation modes are possible. Truck drivers use only AM, while other CB
users in central Europe often use FM.
•
To toggle between the modes press F + AM/FM key
•
If you select AM, an AM icon appears on the display and the letter A appears as first digit of
the frequency display like A26.965
•
If you select FM, the letter F appears as first digit of the frequency, for example F26.565

Other important functions

Factory Reset Options

If the scanner should show any malfunction, which cannot be solved by replacing the batteries or
switching OFF- ON, we prefer to use the reset to the factory default functions. Please note that this
procedure clears all memories and settings (except the German Band and All Band setting). So use
the reset function only in cases where nothing else could help.
To reset to factory default conditions
•
Turn the scanner OFF or take out and re-insert batteries, if there is no reaction.
•
press MONITOR + F key and switch the scanner ON at the same time, while keeping the
buttons pressed.
•
Release all buttons as soon as the scanner is ON. (while switching on, the display shows
that the scanner is initialised).
After Factory Reset, the scanner starts like a new scanner with German Band setting and AIR Band.