Technical Data - TECO 680 Manuel D'utilisation

ing programme.
- General utility programmes:
• independent calibration of the machine's components;
• main screen customisation;
• spin overall and partial number counter;
• selection of the 2 most used programmes;
• visualisation of the service and diagnostics page.
- Independent working environments that allow a maximum of three operators to work
in parallel with no need to reset any data.
- RPA: - Automatic wheel positioning in the position where the balancing weight has to
be applied.
- Possibility to select the position for applying the adhesive weight:
• vertical plane in the lower part of the wheel (H6) using the LASER line;
• vertical plane in the upper part of the wheel (H12);
• CLIP: using the weight-holder terminal in the ALUP balancing programmes (in all
other H12 balancing programmes).
- LED light (if present).
- LASER indicator (if present).
- Single-phase power supply voltage ....... 100/120 ±10%, 200/240 V ±10%, 50/60 Hz
- Rated power ...................................................................................................... 122 W
- Rated current ..................................................1,2 A at 100-120V, 0,6 A at 200-2400V
- balancing speed ........................................................................................ 90/130 rpm
- Maximum unbalance value calculated ........................................................999 grams
- Average spin time (with 5"x14" wheel) ................................................................ 7 sec
- Shaft diameter ..................................................................................................40 mm
- Ambient work temperature ......................................................................... 5° to 40°C
Machine dimensions (Fig.11/11a)
• depth with guard closed ..............................................................................1100 mm
• depth with guard open ................................................................................1130 mm
• width with guard ..........................................................................................1280 mm
• height with guard closed .............................................................................1400 mm
• height with guard open .............................................................................. 1680 mm
• depth without guard .....................................................................................585 mm
• width without guard ....................................................................................1200 mm
• height without guard ...................................................................................1380 mm
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl

TECHniCal DaTa

EN
79