Bosch SmartphoneGrip BSP3200 Notice D'utilisation D'origine page 7

pay attention to road conditions and comply with
traffic laws at all times.
Please note that certain State or local laws may re-
u
quire that class III eBikes must be equipped with a
functioning speedometer that displays speed in
miles per hour. Riders must be aware of any and all
applicable rules and regulations related to the oper-
ation or use of class III eBikes in any applicable ju-
risdictions before operating or otherwise using this
product.
Choose the USB charging cable length appropri-
u
ately. USB charging cable length must not be long
enough to catch in handlebar or front wheel. This is
important to prevent personal injury.
NOTICE: This device complies with part 15 of the
FCC Rules. Operation is subject to the following two
conditions:
1. This device must not cause harmful interference,
and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
NOTICE: Changes or modifications made to this
equipment not expressly approved by the Robert
Bosch GmbH may void the FCC authorization to oper-
ate this equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful inter-
ference to radio communications. However, there is
no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
Bosch eBike Systems
interference by one or more of the following mea-
sures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
– Consult the dealer or an experienced radio/TV tech-
nician for help.
Radiofrequency radiation exposure Information:
The radiated output power of the device is far below
the FCC radio frequency exposure limits. Neverthe-
less, the device shall be used in such a manner that
the potential for human contact during normal opera-
tion is minimized.
This equipment complies with FCC radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
ISED Notice (Canada)
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two con-
ditions:
1. this device may not cause interference, and
2. this device must accept any interference, including
interference that may cause undesired operation
of the device.
This equipment complies with Canada radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
English – 5
0 275 U08 3SG | (28.02.2022)