Viewing The Time; Using The Stopwatch - Logitech G X52 HOTAS Mode D'emploi

Viewing the time

You can choose the time zone for which the current time is displayed from up to three
available time zones. To move between the available time zones, press the up (Start/Stop)
and down (Reset) buttons.
As you move between the three time zones, a number is displayed in the bottom right
corner of the MFD (in place of the date). This number disappears after a few seconds.
Greenwich Mean Time (GMT) is available by default, and is represented by the number 1.
You can choose which other time zones are available and the format in which each time is
displayed. See Maintaining clock settings in the section Maintaining your controller settings
for an explanation of this procedure.
Viewing the date
The date is displayed in the bottom right-hand corner of the MFD. By default, it is shown
in the format MMDDYY. You can change the date format, for example to DDMMYY.
See Maintaining date settings in the section Maintaining your controller settings for
an explanation of this procedure.

Using the stopwatch

The lower part of the MFD can also be
used as a stopwatch. You toggle between
the stopwatch and time displays by pressing
the Function button. When the stopwatch
is selected, the following is displayed:
To use the stopwatch
1. Press Start/Stop once. The number of seconds begins to increase.
2. Press Start/Stop again to stop the timer.
3. Press Reset to clear the time and return to 00:00.
Note: The timer initially shows minutes and seconds. If the time recorded reaches
fifty-nine minutes and fifty-nine seconds, i.e. 59:59, it changes to show hours and minutes.
This means the next reading after 59:59 is 01:00.
17