Tasco 119215C Manuel D'instructions page 10

CAMERA SETuP (continued)
to confirm the month setting you've made. Next, set the Date:
• Press "UP" or "DOWN" to select a date between 01-31, Press "OK" to
confirm. Next, set the Year:
• Press "UP" or "DOWN" to select a year between 10-30 (2010-2030),
Press "OK" to confirm.
Set Time
• The "TIME" indicator (
YEAR settings). Press "OK" to confirm you want to set it.
• The first two digits of the 4 digit display indicate the hour (HH) and
the last two digits indicate minutes (MM).
• Press "UP" or "DOWN" to select an hour between 00-23 (00=midnight,
12=noon, 23=11PM), Press "OK" to confirm. Next, you are ready to
set the minutes.
• Press "UP" or "DOWN" to set the minutes between 00-59, Press "OK"
to confirm.
Note: The Date & Time setting will normally be retained for a few minutes
when the batteries are removed from the camera. However, you may need
to reset the Date & Time after replacing the batteries, if they have been
removed for a longer period of time.
2. Setting Camera/Video Mode and Resolution
This item allows you to select whether the camera takes still photos or
shoots video clips when the PIR is triggered (Photo or Video Mode). You
can also set the number of photos the camera takes for each PIR trigger
(for Photo Mode only). Available settings are 1P, 3P, or video mode.
• The "PHOTO/VIDEO" indicators (
(alternating). Press "OK" to confirm you want to set the capture
mode.
• Press the "UP" or "DOWN" button to select the Photo or Video mode
icon (only the mode you select will be blinking).
10
#2) will blink next (after you confirm the DATE/
#4 & #5) are now both blinking