Product Description - Stiga CP1 434 Serie Manuel D'utilisation

Behaviour
• Exercise caution when reversing or moving backwards.
Look behind you to make sure there are no obstacles
before and during operations in reverse gear.
• Never run, always walk.
• Do not allow the lawnmower to pull you along.
• Always keep hands and feet away from the cutting means,
when starting and when using the machine.
• Attention: the cutting means will continue to rotate for
a few seconds after disengagement or after you have
switched off the engine.
• Keep away from the discharge opening.
• Do not touch the engine parts as they get very hot when
running. Danger of burns.
If something breaks or an accident occurs during
mowing, turn off the engine immediately and move
the machine away to prevent further damage; if
an accident occurs with injuries or third parties
are injured, carry out the first aid measures most
suitable for the situation immediately and contact
the medical authorities for any necessary health
care. Carefully remove any debris which could
cause damage or injury to persons or animals
if ignored.
Use limitations
• Never operate the machine with damaged, missing
or incorrectly assembled guards (grass catcher, side
discharge guards rear discharge guards).
• Don't use the machine if the attachments/tools are not
installed in their seats.
• Never disengage, deactivate, remove or tamper with the
safety systems/micro switches installed.
• Do not alter the engine adjustments, nor over-run it. If
the engine is forced to work with an excessive number of
rotations, the risk of personal injury increases.
• Do not strain the machine too much and do not use a
small machine for heavy-duty work. If you use the right
machine, you will reduce the risk of hazards and improve
the quality of your work.
1.4. MAINTENANCE, STORAGE AND TRANSPORT
Ensure regular maintenance and correct storage to maintain
machine safety and high performance levels.
• Never use the machine with worn or damaged parts.
Faulty or worn-out parts must always be replaced and
never repaired. Use original replacement parts only:
the use of non-original and/or incorrectly fitted parts will
jeopardise the safety of the machine, may cause accidents
or personal injuries for which the Manufacturer is under
no circumstance liable or responsible.
• To reduce the risk of fire, regularly check the machine for
oil and/or fuel leaks.
• While adjusting the machine, pay attention to avoid getting
your fingers caught between the moving cutting device
and the fixed parts of the machine .
• Do not store the machine with fuel in the tank in an area
where fuel vapours could reach a naked light, a spark or
a strong heat source.
• To reduce fire risks, do not leave containers with debris
inside a room.
The noise and vibration levels shown in these
instructions are the maximum levels for use of
the machine. The use of an unbalanced cutting
element, the excessive speed of movement, or
the absence of maintenance have a significant
influence on noise emissions and vibrations.
Consequently, it is necessary to take preventive
steps to eliminate possible damage due to high
levels of noise and stress from vibration. Maintain
the machine well, wear ear protection devices,
and take breaks while working.
1.5. ENVIRONMENTAL PROTECTION
• Scrupulously comply with local regulations for the disposal
of packaging, deteriorated parts or any elements with
a strong environmental impact; this waste must not be
disposed of as normal waste, it must be separated and
taken to specified waste disposal centres where the
material will be recycled.
• Scrupulously comply with local regulations for the disposal
of waste materials
• When the machine is withdrawn from service, do not
dispose of it in the environment, but take it to a waste
disposal facility in accordance with the local regulations
in force.
2.

PRODUCT DESCRIPTION

This machine is pedestrian controlled lawnmower.
The machine essentially consists of an engine, which drives
a cutting device enclosed in a casing, equipped with wheels
and a handle.
The operator is able to operate the machine and use the main
controls, always staying behind the handle at a safe distance
from the rotating cutting means.
If the operator leaves the machine, the engine and cutting
means will stop within a few seconds.
Intended use and improper use
This machine is designed and built for cutting grass in gardens
and grassy areas.
Any other usage may be hazardous and harm persons and/
or damage things.
Examples of improper use may include, but are not limited to:
• transporting other people, children or animals on the
machine;
• being transported by the machine;
• using the machine to tow or push loads.
• operate the cutting device in non grassy areas;
• using the machine for collecting leaves or debris;
• using the machine to trim hedges, or for cutting vegetation
other than grass;
• use of the machine by more than one person.
IMPORTANT Improper use of the machine will invalidate the
warranty, relieve the Manufacturer from all liability, and the user
will consequently be liable for all and any damage or injury to
himself or others.
This machine is intended for use by consumers, i.e. non-
professional operators. The machine is intended for "DIY"
use only.
IMPORTANT The machine must be used by one operator.
EN - 2