Publicité
Les langues disponibles
Les langues disponibles
Fault codes:
Code
Status
Signal "E1" is flashing on LCD,
E1
accompanied with "beep"
alarms heard.
Signal "E2" is flashing on LCD,
E2
accompanied with "beep"
alarms heard.
Signal "
accompanied with "beep"
alarms heard.
Signal "E4" is flashing on LCD,
E4
accompanied with "beep"
alarms heard.
Cleaning:
1. Before you clean the appliance, switch the appliance off and remove
the plug from the socket.
2.
While cleaning, don't immerse the bowl in water.
3. After the bowl cool down, remove the 4-blade knife from the bowl. Clean
the inside and outside of the bowl. Always keep the contact pins at the
bottom of the bowl clean and dry. Only wipe the contact pins with a wet
cloth!
4. Unscrew the screw ring and remove all parts of the attachment. Don't
clean the metal bowl and blade in the dishwasher!
5. Never use pointed or sharp objects for cleaning as this may damage
functional parts or affect the safety of the appliance.
6. The 4-blade knife is very sharp! Handle it with care!
7. Wash all parts in hot soapy water. Clean them immediately after use.
Rinse them with clear hot water and dry them immediately.
8. We advise you to lubricate the 4-blade knife with some vegetable oil.
" shows on LCD,
Solution
Something goes wrong with the
appliance. It must be sent to the
approved service center for
repairing.
The bowl wasn't installed, or
install incorrectly. Install the bowl
again according to the
operating instruction.
The bowl cover wasn't installed,
or install incorrectly. Install the
bowl cover again according to
the operating instruction.
The temperature of appliance is
too hot. Firstly let it cool down 30
minutes to 2 hours, and then
reboot it. It must be sent to the
approved service center for
repairing if the previous
cooperation doesn't work.
EN-17
Publicité
