Error Messages And Warnings - RC-Plus I-POWER 680 Manuel D'instructions

ERROR MESSAGES AND WARNINGS

This charger incorporates a variety of functions for protection, these monitor the system to verify
processes and the state of the electronics.
In case of an error the screen will display the cause of error and emit and audible sound.
The output is connected to a battery with incorrect polarity.
This will be displayed if the unit detects a break in the circuit between
the battery and output or if the battery is voluntarily disconnected during
the charge process.
There was a short circuit at OUTPUT.
Erroneous selection of voltage of Lithium pack, please check the volt-
age of the battery pack.
The voltage of the battery pack has been selected incorrectly!
The charger has malfunctioned for some reason. Seek professional
advice.
The processor detects that the battery has dropped below the minimum
voltage during the charge process.
The voltage is higher than which is set. Please check the number of
cells in the battery pack.
Voltage of one cell in the battery pack is too low, please check the volt-
age of each cell.
Voltage of one cell in the battery pack is too high, please check the
voltage of each cell.
Wrong connection of the connector detected; please check the connec-
tor and cable.
The internal temperature is too high, please cool down.
The processor cannot control the feeding current, please repair it.