Setting Up The Titration System - Radiometer Analytical ABU62 Guide D'utilisation

Setting up the titration system

Setting up the titration system
Setting up the titration system
Setting up the titration system Setting up the titration system
Warning ! Warning ! Warning !
Warning ! Warning !
The ABU62 have been developed to meet the requirements of
electrochemical applications. It is therefore aimed at experienced users
who have the knowledge required to operate the instrument and
implement the security instructions enclosed. Please remember that the
ABU62 must not, under any circumstances, be used to perform tests on
living beings.
We accept no responsibility for using the ABU62 and its peripheral
devices under conditions that are not specified in this User's Guide and
its associated TitraLab 9xx Reference manuals (part no. D21T073 for a
TitraLab 960/965 or D21T075 for a TitraLab 980).
The ABU62 is used in association with the following Titration Managers:
TIM960, TIM965 and TIM980. All Titration Managers or ABU62 in the
system should have the same version of embedded software installed
preferably from the Radiometer Analytical
centre.
1. Set up the instrument in a properly ventilated place. The power
supply connector on the rear panel must remain accessible and
close to the user (2 m maximum) so that you can quickly
disconnect the cables in case of emergency.
The room temperature should not exceed 40°C.
www.titration.com
6
resource