Wall Mounting Instructions; Mounting Notes - Ksenia Lares KSI1000016.300 Manuel D'installation

1. Metal bottom
2. Large holes for passing cables
3. Bottom securing holes
4. System's board brackets
5. PC board brackets
auxi
6. Anti-tamper micro-switch
7. Micro-switch cable + connector
8. Earth connections on threaded pin and nut
9. Control panel board
10. Control panel micro-controller
11. Interconnection terminals
12. Programming USB connector
In order to correctly install the metal cabinet and the components inside it, please follow the instructions here below:
1. Fix the metal cabinet to the wall using Ø 0.32 inch screws (options)
In order to maintain the conformity with the listed norms at page 15, install a screw in correspondence to the tamper
2. Extract the support for power supply unit. (20)
3. Fix the power supply unit to its support using the provided M3 screws.
4. Place the support back.
5. Wire the cables as shown in picture.
6. Ensure the cables to the fixing holes (21).
• Arrange outside the Panel an isolating device (es. Circuit Breaker Device 16A Curve C).
• The two power supplies have respectively two internal fuses (25W - T2AL / 50W - F3.15AL).
In case should fail, its replacement requires the opening of the power supply and must therefore be carried
out by authorized personnel.
• Wire the earth connection directly on the power supply unit.
• The power supply conductors must be 0,6 inch.² minimum section.
MADE IN ITALY
A-BBBB
13. USB key (optional)
14. Power supply cable
15. 12V battery
16. Switching power supply unit
17. Battery terminals
18. Power supply unit terminals
19.
20. Support for power supply unit
21. Holes for cables fixing
22. 2A Fuse
23. ETHERNET connector

WALL MOUNTING INSTRUCTIONS

MOUNTING NOTES

• Depending of the installed power supply unit and Control Panel, check
the relative box in the label using a petroleum solvent resistant pen,
outside the metal cabinet.
• Power supply unit RS25-15
Ksenia Code KSI7101217.000
• Power supply unit RS50-15
Ksenia Code KSI7101230.000
PC board brackets
gemino
lares
200mA max
25W
500mA max
50W
16-IP 48-IP 128-IP
EN
24