Chamberlain LiftMaster PROFESSIONAL 972LM SECURITY+ Manuel Du Propriétaire

Model 972LM Security✚
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
CAUTION
• ALWAYS keep remote controls out of reach of children.
NEVER permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to door
travel.
• ALWAYS keep gate or garage door in sight until completely
closed. NEVER permit anyone to cross path of moving gate
AVERTISSEMENT
or door.
The 972LM remote control can activate two separate residential or commercial garage door openers and/or gate openers.
The instructions for programming garage door openers are illustrated below. Please refer to the original receiver program-
ATTENTION
ming for commercial and gate products.
Both push buttons are factory programmed to work with Security✚
code between these channels and the receiver changes with each use, randomly accessing over 100 billion new codes.
As an added feature, the push button on the right is capable of learning or being trained to duplicate or match another CGI
manufactured fixed code or billion-code remote. This feature is normally used when several remotes are required to oper-
ate one fixed code device such as a gate opener or commercial dock door. In this case, the code transmitted to the receiv-
er remains constant or fixed, not using the Security✚
NOTE: The push button on the left cannot be changed from Security✚
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and the hold "learn" button on motor unit until the learn indicator light goes out (approxi-
mately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless
entry you wish to use.
® 2-Button Remote Control
OWNER'S MANUAL
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
receivers having an orange "learn" button. The rolling
®
format.
®
Instructions are described and illustrated below.
1.Press and release the "learn" button
on the motor unit. The learn indica-
1 2 3
tor light will glow steadily for 30
9 1 9 1
7 3 7 3
5 5
KG KG
seconds.
2. Within 30 seconds, press and hold
1 2
the button on the hand-held remote
that you wish to operate your
garage door.
3. Release the button when the motor
unit light blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
WARNING
WARNING
Figure 1
AVERTISSEMENT
AVERTISSEMENT
®
, only the right button is trainable.
Right
Push Button
(Multi-use)
1
2 3
KG KG
1 2 3
KG
KG