Capacity Indicator; Settings; Tool Holder, Attachments - Festool T18+3 Notice D'utilisation D'origine

2
2b
The battery pack is ready to use straight out of
the box and can be charged at any time.
8.2

Capacity indicator

The capacity display [1-3] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-2] is pressed:
Recommendation: Charge the battery pack
*
before any further use.
Further information about the battery pack
and charger can be found in the corre­
sponding operating manual.
9

Settings

CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
9.1 Changing direction of rotation [1-6]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
1
70–100%
40–70%
15–40%
< 15%
*
9.2 Changing gear [1-8]
Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
9.3 Fastening
Adjust the switch so that its marking [1-11]
faces the screw symbol [1-10].
Adjust the torque accordingly at the torque
wheel [1-12].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset tor­
que is reached and the machine then switches
off. You must release and press the ON/OFF
switch [1-5] again to start the machine.
9.4 Drilling
Adjust the switch [1-11] so that its marking
faces the drilling symbol [1-9]. Maximum tor­
que is set in this position.

10 Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
10.1 CENTROTEC tool chuck [3]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
English
11