Technical Data - Weed Eater WE20HT Manuel D'instructions

a WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
Trouble
Hedge trimmer fails to operate
Hedge trimmer operates
intermittently
Cutting blade stops under load
Fails to stop when one switch lever
is released.
Poor cut quality
Rated voltage
Rated power
Cutting length
Maximum cutting diameter
Sound power level
Vibration level
Weight
Protection class
Environmental protection
• Waste electrical products should not be disposed of with household waste.
• Please recycle where facilities exist.
• Check with your local authority or retailer for recycling advice.
TROUBLESHOOTING
Cause
1. No power
2. Faulty wall outlet
3. Extension cord damaged
4. Circuit breaker shut off or faulty
1. Extension cord damaged
2. Loose internal connection
3. Internal wiring defective
4. Trigger defective
Cutting too fast
Internal wiring defective
1. Debris caught in blades
2. Damaged blades

TECHNICAL DATA

Remedy
1. Check power
2. Use another outlet
3. Check cord, replace
4. Reset or replace circuit breaker
1. Check cord, replace
2. Call an authorized service center
3. Call an authorized service center
4. Call an authorized service center
Cut at a slower pace.
Call an authorized service center
1. Clear debris from blades
2. Call an authorized service center
WE20HT
120V~60Hz
400 W
50 cm (19.7 in)
Ø17 mm (0.67 in)
96 dB(A)
30 m/s
3.27 kg (7.2 lb)
/ II
2