Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
Mounting the tube
1. Connect both parts of the tube (5) as shown.
2. Slide the tube into the housing.
3. Fit the tube using the screws.
4. To remove the tube, remove the screws and pull the tube
out of the housing.
Switch off and unplug the appliance before mounting or
removing the tube.
Mounting the collection bag
1.
Place the collection bag (7) onto the connection (6). .
Make sure to slide the collection bag opening past the
2.
raised edge.
Fit the brace to the suspension point .
3.
Selecting the operating mode
Select the required operating mode before use (blowing or
vacuuming).
•
For blowing, turn the switch (2) to the blowing symbol.
•
For vacuuming, turn the switch to the vacuuming symbol.
Adjusting the guide handle
The guide handle (4) can be adjusted to achieve a good balance.
•
Loosen the adjustment knob.
•
Set the handle to the desired position.
•
Carefully tighten the adjustment knob.
Instructions for use
1. Connect the appliance to a suitable extension cord.
2. Hold the appliance with both hands.
3. Slowly move the appliance back and forth.
4. Keep the wheels on the ground during use to reduce the
workload.
Switching on and off
To Switch on the appliance: just push the switch (1) forward to
ON position, it starts working;To Switch off the appliance: just pull
back the switch(1) to OFF position.
The protection of hearing.
Weighted root mean square acceleration value according
2
4.77 m/s
Cleaning and maintenance
The machine does not require any special maintenance.
•
Regularly clean the ventilation slots.
•
Regularly remove leaves and dirt from the tube, the
housing and the outlet opening.
Guarantee
Refer to the enclosed guarantee conditions for the terms and
conditions of guarantee.
Environment
Should your machine need replacement after extended
use, do not put it in the domestic waste but dispose of it
in an environmentally safe way.
Service and Support
If your
Leaf Blower/Vacuum
please call 1-866-766-9563 for assistance.
Model and Serial Numbers
When contacting the company or reordering parts, you will
need to provide the model and serial numbers of your product.
These are found at the bottom of your Leaf Blower/Vacuum.
Copy these numbers into the space provided below.
Record the following numbers from the housing or handle of your
new product:
0 2 3 2 5 0 0 5
requires service or
maintenance,
Model #:
Serial #:
13
Publicité
Table des Matières
