Safety Instructions - LABBOX V05 Serie Mode D'emploi

1. Safety Instructions

Wear the personal safety items to avoid the risk from
•
Splashing of liquids.
-
Mechanical vibration may lead to glass breakage.
-
Trapping parts of the body, hair or pieces of clothing in the moving parts.
-
During manual manipulation:
•
Keep medium vessels vertical as much as possible.
-
Mix the medium in the minimum pressure required.
-
Set up the instrument in a spacious area on a stable, clean, non-slip, dry and fireproof
•
surface. Do not operate the instrument in explosive atmospheres, with hazardous
substances or under water.
Put the speed control knob to the lowest position. Gradually increase the speed, reduce the
•
speed if:
The medium splashes out of the vessel because of too high speed.
-
The instrument is not running smoothly or moves on the stage.
-
Safe operation is only guaranteed with the accessories described in the "Accessories"
•
chapter.
Accessories must be securely attached to the instrument and cannot come off by
•
themselves.
Check the instrument and accessories before each use. Do not use damaged components.
•
Place a vessel at the center of the mixing head.
•
A sharp edged vessel can wear-out the mixing head.
•
Always disconnect the plug before fitting accessories.
•
The instrument may heat up when in use.
•
The operating voltage required on the label and voltage supply network must match.
•
Protect the instrument and accessories from bumps and impacts.
•
The instrument may only be opened by qualified and trained technician.
•
Warning!
Read the operating instructions
•
carefully before use.
Ensure that only trained staff works
•
with the instrument.
Protective ground contact!
Make sure that socket must be
•
grounded (protective
contact) before use.
3
ground