Important Safety Instructions - EHEIM 2250 Mode D'emploi

INSTRUCTIONS FILTER 2250, 2260
IMPORTANT SAFETY
INSTRUCTIONS
WARNING
– To guard against injury, basic safety precautions
should be observed, including the following.
READ AND FOLLOW ALL
a )
SAFETY INSTRUCTIONS.
DANGER
b )
should be taken since water is employed in the use of aquar-
ium equipment. For each of the following situations, do not
attempt repairs by yourself; return the appliance to an author-
ized service facility for service or discard the appliance.
1 ) If the appliance falls into the water,
First unplug it and then retrieve it. If electrical components
of the appliance get wet, unplug the appliance immediately.
(Non-immersible equipment only)
2 ) If the appliance shows any sign of abnormal water leakage,
immediately unplug it from the power source. (Immersible equip-
ment only).
3 ) Carefully examine the appliance after installation. It should
not be plugged in if there is water on parts not intended to
be wet.
4 ) Do not operate any appliance if it has a damaged cord or
plug, or if it is malfunctioning or has been dropped or da-maged
in any manner.
5 ) To avoid the possibility of the appliance plug or receptacle
getting wet, position aquarium stand and tank to one side of
a wall-mounted receptacle to prevent water from dripping onto
the receptacle or plug.
A "drip-loop", shown in the figure below, should be arranged by
the user for each cord connecting an aquarium appliance to a
receptacle. The "drip-loop" is that part of the cord below the
level of the receptacle, or the connector if an extension cord is
used, to prevent water traveling along the cord and coming in
contact with the receptacle.
If the plug or socket does get wet,
Disconnect the fuse or circuit breaker that supplies power
to the appliance. Then unplug and examine for presence of
water in the receptacle.
– To avoid possible electric shock, special care
DON'T
reach for it !
DON'T
unplug the cord.