Control Panel (Non-Steam Models) - LG LDS6040ST Manuel Du Propriétaire

10
PARTS AND FEATURES

CONTROL PANEL (non-steam models)

Display varies by model (LDF7561, LDF7551)
Display varies by model (LDS6040)
Cycles
Select your desired cycle.
POWER SCRUB
This cycle is for heavily and hard soiled dishes.
DUAL WASH
This cycle washes the upper and lower racks at different spray
intensities. The default setting for this cycle washes the low-
er rack with strong spray intensity and the upper rack with
soft spray intensity. This provides optimum cleaning perfor-
mance for mixed loads, including fine china and stemware. If
other combinations are desired, use the steps listed below to
change the intensities or to use the HALF LOAD feature.
How To Use Dual Wash:
1. Select Dual Wash.
2. Press the Spray button to toggle between Soft, Medium
and Strong for the upper spray arm.
3. After making your selection for the upper spray arm, press
the Half Load button.
4. Press the Spray button to toggle between Soft, Medium
and Strong for the lower spray arm.
5. Close the door to start the cycle.
DELICATE
The cycle is intended for effectively cleaning delicate items
such as fine china and stemware.
NORMAL
This cycle is for normally soiled, everyday loads.
QUICK & DRY
This is a shortened cycle that is intended for washing and dry-
ing recently used dishes or lightly soiled loads. During this
cycle, both spray arms will run at the same time.
QUICK
This is a shortened cycle that is intended to wash recently
used or lightly soiled loads, without drying.
RINSE ONLY (LDS6040)
This cycle is a quick rinse for dishes that will not be washed
immediately. This cycle will rinse dishes that have excess soil
to soften dried on residue. Rinsing the dishes will help pre-
vent odors in the dishwasher. No detergent should be used.
CHIME ON/OFF
To enable or disable the chime, first, turn on the dishwasher.
Press and hold the Quick and Delicate buttons (LDS6040
: Spray and Delay Start) simultaneously for approximately
three seconds.
TO CANCEL A CYCLE
To cancel a cycle, open the door and then press and hold the
Delicate and Normal buttons (LDS6040 : Spray and Half Load)
together for approximately three seconds. The drain pump
will activate and the cycle will cancel. The display will show
"dr" and the dishwasher will drain the water. After the dish-
washer is drained, the power will turn off.
If power is turned on and no cycle has been selected, the
dishwasher will power off within four minutes.