Settings Menu - Arcam HDA CDS50 Manuel

Settings Menu

The Settings menu allows you to configure all aspects
of your CDS50. This section will go through the menu
items and explain their function.
The only way to view the Settings menu is on the CDS50
front panel display.
Entering the settings menu
<
To access the Settings Menu, press
to stop any
playback and wait for the CDS50 to display the home
C to scroll down to the Settings Menu
screen. Press
item and press OK to enter.
Navigating the menus
The CDS50 menus can be navigated by using the cursor
(arrow) keys on the remote control.
' ,
1. Use the and keys to navigate up and down
the current menu
2. With the main section you require displayed, press
OK to select it
' ,
3. Use the and keys to navigate up and down
the options
> '
4. Pressing selects a setting: use the and
keys to change the setting
5. Press OK to confirm the setting. Go back to step 4 to
adjust any other settings in the current section
<
6. Press to return to the previous screen if you want
to select another section to adjust
Network Standby
This item determines whether network features are
available when the CDS50 is in standby.
Selecting "ACTIVE" will maintain the network connection
(required for IP control).
Selecting "STANDBY" will allow the network hardware
to be powered down in order to reduce power
consumption.
Network Setup
This item allows the user to configure the unit to join an
existing network, required for network audio playback
and over the internet software updates.
Auto Standby
Allows user to specify the period of inactivity after
which the unit will automatically enter standby. The
options are: 5, 10, 15, 20, 25 and 30 minutes
Disc Auto Playback
Controls whether an optical disc (e.g. CD) will play
automatically after it is inserted.
,
On: Optical discs will play automatically
Off: Play must be pressed to play a disc
Firmware Update
You can check for an upgrade to your player's firmware
by selecting this menu item and pressing OK to
highlight 'Network' , then press OK again.
A message appears if no new firmware is available,
otherwise follow the instructions shown on the display.
Load Defaults
Press OK with this item highlighted to reset all settings
to factory defaults.
You are asked to confirm that you want to load the
factory default settings. Select "cancel" to exit or
highlight the "yes" option and OK to confirm.
System Information
' ,
Use the and cursor keys to browse through
options.
The System Information panel shows information about
your player, such as the IP address and firmware version
Network Audio
Allows the user to enable or disable the UPnP rendering
capability of the player. Setting this option to 'off' will
disable network audio.
Digital Audio
Allows the user to limit the sample rate of the coax/
optical digital output.
'
to
EN-12