Installation Procedure Of Drain Pump Kit; Before Installation - Toshiba Carrier TCB-DP22CUL Manuel D'installation

Drain Pump Kit
3
INSTALLATION PROCEDURE
OF DRAIN PUMP KIT
n Before installation
1. Removal of suction grille
Slide the suction grille fixing knobs
(2 positions) toward the arrow direction, and
then open the suction grille.
Under the condition of suction grille opened,
push the hook section of hinges (2 positions) at
the rear side, and then pull out the suction
grille.
Hinge
Suction grille
Suction grille
fixing knob
2. Wire guard open
Remove the screws (2 pcs.) which are fixing
the wire guard. Using clamps mounted to the
wire guard, hang up the wire guard.
• Do not remove the fixing screws of clamps of
the indoor unit.
Clamps
Screws
English-5
Pull out suction grille
while pushing hook.
NOTE
After installation of the Drain Pump Kit, be sure to
mount the wire guard as original.
Do maintenance work after removing the screws
which are fixing the wire guard and hanging up the
wire guard with the clamps.
3. Removal of side panel
After removing the side panel fixing screws
(1 each at right and left), slide the side panel
forward and then remove it.
Removing the side
panel fixing screws
Side forward
6
Installation Manual