Configuration; System Setup; Date Time Setup; Network Setup - Western WRD Manuel De L'utilisateur

Configuration:

The WESTERN WRD SYSTEM can work with different combinations of devices:
1. WRD + WBM (battery monitoring)
2. WRD + WRMxx
(1..8)
3. WRD + WBM + WRMxx
Depending on the current hardware, the configuration must be set on the WRD. This operation is performed on the
menu: 8.0 WBUS CONFIG. where the addresses of the devices connected to the device must be specified WBUS to
facilitate the operation an auto configuration command is available that detects the connected hardware.
Depending on the configuration set, the WRD displays the information and can execute its algorithms using the available
resources. The screens for each configuration are described below.

System Setup:

In the menu: 7.0 SYSTEM the system settings are executed, the list of parameters changes according to the current
configuration. Detailed explanations are described in the chapter Configurations.

Date Time Setup:

In the menu: 7.1 DATE / TIME you set the system clock and the time zone (Timezone). It is important to correctly set this
last parameter with the Timezone of the place where the system is located, so that the remote clock can be updated
correctly.
Data Logger Setup:
In the menu: 7.2 DATA LOGGER you can enable the data logger by setting the minutes for the sampling parameters:
10min. is the default value (enabled). It is also possible to request information regarding the μSD.

Network Setup:

In the menu: 7.3 NETWORK you make the settings of the various network parameters. The DHCP function is set by
default, which automatically retrieves the necessary values. The connection to the remote server can be enabled or
disabled by the user.
(PV production monitoring)
(storage monitoring, production, consumption on stand-alone systems)
(1..8)
WRD
User manual
3
EN