Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Black Thumb
Screw
press
FIG. 5
STEP 4
Now place the child carrier on the support bar and attach using the thumb screw.
The seat can slide back and forth to your preference.
WARNING: The movability of the handlebar may be reduced by the child seat.
It may be necessary to change the type of handlebar you have if the steering is
reduced to less than 45º.
Once you have found the desired position, tighten the thumbscrew. Make sure all
of the bolts and screws are carefully tightened before using the child carrier. FIG. 5.
When securing hardware, apply normal hand tightening using the tools supplied/
required. Torque requirement 10 Nm.
NOTE: When you want to ride your bike without the child carrier, remove the child
seat by loosening the thumb screw. It is not necessary to remove the support bars.
Your seat has been equipped with a secure strap. Fit the strap around the mounting
bar and tighten securely.
8
manual WeeRide.indd 8
11/01/11 03:14
Publicité
Table des Matières
