Zeegma Zonder Robo Next Manuel De L'utilisateur page 12

EN
PROBLEM
The vacuum cleaner
does not charge.
The vacuum cleaner
has difficulties in
vacuuming.
The vacuum cleaner
returns to the
docking station
automatically.
The vacuum cleaner
does not activate
during scheduled
vacuuming.
Remote control does
not work
APPLICATION
1. Download and install „WeBack" application (see fig. 16)
•
Scan QR code or find „WeBack" application in GooglePlay store or iOS store, download
it and install.
2. Sign up/ log in (see fig. 17)
•
Enter the application, enter your phone number or e-mail address. Enter your password
to receive the verification code. Next read and accept the Privacy Policy.
•
Enter the verification code in the empty field. Go further.
•
Next log in the application by entering the correct phone number or e-mail address
and password.
3. Scan the vacuum cleaner with QR code (see fig. 18)
•
Log in the application, click „+", scan QR code on mobile device and click „enter
manually".
POTENTIAL CAUSE
No connection with the
docking station.
The battery does not charge.
The vacuum cleaner wraps in
elements of the room (cables,
drapes, etc.).
Low battery.
End of work time.
Vacuum cleaner is off
Low battery
Dustbin is clogged or other
elements are obstructed.
Batteries in remote control
are flat.
The vacuum cleaner is off or
battery is low.
Infrared signal is not received
by the device.
SOLUTION
Make sure charging ports of the vacuum cleaner and docking
station are properly connected. Try to place the product on
the docking station manually.
Make sure the docking station is plugged in. If you have not
used the vacuum cleaner for a long time and battery does
not charge, place the cleaner on the docking station and
charge for 3 minutes, then stop charging. Repeat 3 times
and then start charging the vacuum cleaner normally.
The vacuum cleaner tries to steer clear of obstacles. If it
is impossible, remove obstacles before you start another
vacuuming.
This operation is normal.
This operation is normal.
Switch the vacuum cleaner on.
Charge the battery.
Switch the device off and clean the dustbin and filters.
Replace batteries in the remote control.
Switch the device on and/or charge the battery.
Clean the infrared sensor on the device and remote control.
Check the space between the remote control and device for
any obstacles blocking the signal and other items emitting
infrared signal (e.g. TV remote control).