Problem Solver; Before You Call For Service - GE Monogram ZCGP150 Mode D'emploi

Questions? PROBLEM
Use this
Compactor won't
operate
Problem
Solver
Drawer is hard
to close
Drawer will not
open
Little or no apparent
compaction

Before You Call For Service

POSSIBLE CAUSE
Compactor is unplugged
Circuit breaker/fuse is
tripped/blown
Knob switch may not be
in the ON position
Foot pedal may not be
lifted up long enough to
start cycle
Drawer may not be closed
Compactor has an
automatic thermal
motor reset
Trash may have fallen
behind the drawer
The ram is not all the
way up
Drawer is not full enough
Trash is stuck between
ram and basket
Compactor
WHAT TO DO
• Make sure the cord is plugged securely into
a working outlet.
• Check house circuit breakers/fuses.
Replace fuses or reset breaker.
• Make sure the switch is in the ON position.
• Lift foot pedal up momentarily until
compaction cycle starts.
• Check to make sure the drawer is firmly
closed.
• If you have just compacted repeatedly,
this protector may have opened the motor
circuit. Wait a few minutes and the motor
reset will reclose automatically.
• Remove any trash.
• Lift up on the foot pedal and release to
allow ram to complete a cycle.
• The drawer must be at least 1/2 full of
trash before you will see any amount of
compacting. The ram does not travel all the
way to the bottom. Trash in the bottom of
the drawer will be crushed during later
cycles.
• Remove any trash.
11