Federal Communication Commission Interference Statement; Industry Canada Statement - Iomega ScreenPlay TV Link DX Guide De Démarrage Rapide

Regulatory Information • Informations relatives à la réglementation
Manufacturer/Responsible Party
Iomega Corporation
4059 South 1900 West
Roy, UT 84067 USA

Federal Communication Commission Interference Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment.
FCC Radiation Exposure Statmeent (for WiFi adapter):
This equipment complies with FCC ratiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20cm between the raidator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.

Industry Canada Statement

This Class B digital apparatus complies with Canadian ICES-003.
The WiFi adapter complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:
1. this device may not cause interference and
2. this device must accept any interference, including interference that may cause undesired operation of the device.
IMPORTANT NOTE – IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. To maintain compliance with IC RF exposure compliance requirements, please
follow operation instruction as documented in this manual.
Notice relative à l'industrie canadienne
Cet appareil numérique de Classe B est conforme à la directive canadienne ICES-003.
L'adaptateur WiFi
est conforme à la norme RSS-210 de la réglementation canadienne s'appliquant à l'industrie.
à deux conditions :
1) Cet appareil ne doit pas provoquer d'interférences, et
2) Cet appareil doit supporter toute interférence, pouvant notamment entraîner un fonctionnement imprévu.
REMARQUE IMPORTANTE – Déclaration d'Industrie Canada relative à l'exposition aux radiations :
Cet appareil est conforme aux limites d'exposition aux radiations de la IC définies pour un environnement non-contrôlé. L'utilisateur
final doit suivre les instructions d'utilisation spécifiques pour respecter la conformité relative à l'exposition aux radiofréquences.
Pour maintenir la conformité aux normes sur l'exposition aux radiofréquences, vous devez suivre les instructions d'utilisation
décrites dans le présent manuel.
T
his equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Son utilisation est soumise
11