Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Jetpolisher 2000™
Your Jetpolisher 2000 airpolishing unit incorporating the H.S.T.™
Homogenous Stream Technology polishing system represents the very
latest in air abrasive polishing technology and incorporates many advanced
features that will provide many years of trouble free, efficient operation
U.S. Federal law restricts this device to sale by or on order of a dentist
Among the advanced design features are the following:
 Self-cleaning/non clogging head
 Homogenous mixture
 Atomised rinsing mode
 Separate air and water controls
 Lower pressure for safer cleaning
 Easy view powder chamber No need for routine maintenance
Attention: refer to accompanying documents

APPLICATIONS

Routine
Airpolishing has been shown to be harmless to intact
polishing
enamel, and can save up to a 50% of time needed to
remove heavy stain or for routine polishing after
scaling, as compared to a regular prophy cup or brush
method.
Pre-etching
The Jetpolisher 2000 is the method of choice for pre-treatment of
or Bleaching
enamel prior to etching or bonding in cosmetic dentistry. Difficult to
reach areas, such as interproximally where crowding exists, can be
cleaned effectively to ensure a good bond. Prior to bleaching, the
enamel surface should be thoroughly cleaned with the Jetpolisher
2000.
Fissure
The long term success of fissure sealing to some extent depends on
sealing
the surface area of the bond, and the deeper the fissure is cleaned of
plaque, the greater the penetration of the bonding material. The
Jetpolisher 2000 can clean these areas more efficiently than
conventional methods and leaves no residue.
Orthodontics
There is no substitute for the Jetpolisher 2000
method for cleaning around fixed orthodontic
appliances, especially in mouths where optimum oral
hygiene is not being maintained. Prior to bonding of
bands and brackets, the enamel surface can be
thoroughly cleaned with the Jetpolisher 2000 to
effect a reliable bond. The surface should be rinsed
twice before etching.
4
ENGLISH

Publicité

Table des Matières
loading

Table des Matières