Trap Assembly - Post Mount - Champion SKYBIRD TRAP Manuel De L'opérateur

TRAP ASSEMBLY INSTRUCTIONS – POST MOUNT
FIGURE 5
Tubes Front Tube Support (K)
Connect
6MM X 90MM
STEP 1.
TRAP BODY TO POST MOUNT (FIG 5-6)
Mount the Pivot Mount (F) to the Post Mount (M)
assembly using the 12MM Hex Nut (N-2). Orientate
the Pivot Mount (F) so that the serrated face of the
pivot mount faces to the right as shown. Tighten
hex nut securely. After mounting the Pivot Mount,
attach the trap to the pivot mount using the 12MM x
30MM Lg. Hex Bolt (N-1). Pivot the trap slightly above
horizontal and tighten the hex bolt securely. This
setup will provide a good starting point for target
launch direction. Attach Trap Body Handle (O) to Trap
Body using bolt and washer on Trap Body Handle.
Front of Trap Body Handle fits under top of trap body
into slot and is then bolted to Trap Body.
Attach Trigger (Q) to tab on Trap Body (B) using 2
Bolts (N-20).
STEP 2.
TUBE SUPPORT ASSEMBLY (FIG-5)
Insert two 6MM X 90MM Lg. Hex Head Bolts (N-12)
through holes in the short Rear Tube Support (N-15),
through holes in sides at rear of Trap Body (A) and
through second Rear Tube Support (N-15). Attach
6MM Flange Nuts (N-13).
Front Tube Support (K)
6MM X 90MM
Hex Bolts
(N-12)
Tubes
Connect
Rear Tube
Support (N-15)
Hex Bolts
(N-12)
12MM Hex Nut
(N-2)
12MM x
30MM Hex
Bolt (N-1)
MAKE SURE WARNINGS ON FRONT TUBE
SUPPORTS ARE UPRIGHT.
Tighten all four nuts on Tube Supports securely.
Slide three pieces of Tubing (L) over ends of Front
Tube Supports (K) and Rear Tube Supports (N-15).
This ring indicates the approximate path of the
Throwing Arm (A).
7
Arm Path Indicator Tubing (L)
6MM
Trigger (Q) &
Flange Nuts
6MM x 12MM Lg. Bolts (N-20)
(N-13)
Trap Body (B)
Tubes
Connect
Pivot Mount (F)
Post Mount (M)
FIGURE 6
6MM
Flange Nuts
(N-13)
Tubes
Connect
Rear Tube
Support (N-15)
6mm x 24mm
Hex Bolt &
M6 x 18mm
Washer
(N-21 & N-22)
Trap Body Handle (O)