Troubleshooting Tips - U.S.Robotics SureConnect 9003 Guide D'installation Rapide

On Green
PWR
On Green/10 Mbps
On Orange/100 Mbps
ENET1
Flashing Green or
ENET2
On Green
USB
Flashing Green
On Green
ADSL
Flashing Green

Troubleshooting Tips

None of the LEDs illuminates when I turn on the router.
• Check the connection between the power adapter, router, and wall
outlet.
• Confirm that you're using the power adapter that came with your U.S.
Robotics SureConnect ADSL Ethernet/USB Router package.
The ADSL light is flashing or is not illuminated.
• Make sure that the telephone cable connects properly at the "ADSL"
port on the rear of the router and at the phone wall jack.
I can't connect to the router's configuration utility.
Possible Solution 1:
• Make sure that Ethernet or USB cables connect properly and securely.
• Make sure that you've plugged in the power cord.
Possible Solution 2:
• Make sure that your PC is using an IP address within the range of
192.168.1.2 to 192.168.1.254.
• Make sure that the address of the subnet mask is 255.255.255.0.
Receiving power from the wall jack power supply.
Off Detected no power.
Established and detected a physical connection
through the Ethernet cable between router and
computer.
Flowing data traffic.
Orange
Did not establish a physical connection between
Off
router and computer.
Established and detected a physical connection
through the USB cable between router and com-
puter.
Flowing data traffic.
Did not establish a physical connection between
Off
router and computer.
Established a DSL link.
Negotiating a DSL link.
Off The DSL link failed.
13