Remote Control Mode - Thermor Equateur Notice D'installation Et D'utilisation

2-3) Locking the panel heater onto its wall bracket :
Horizontal Model:
- Mount the panel heater on hooks S as shown in the diagram
- Bring back the panel heater towards the support then to raise (arrow 1 and 2).
- Introduce the legs of the support into the holes of the panel heater and lower (arrow 3). Your panel heater is fixed.
6 6 6 6 6
Hight Model : bis
Install the device on the S support as shown in diagram
Lock it by turning the V loch through a quarter turn.
1
2
S
1) Description of the control unit 7 7 7 7 7
Mode switch slider.
Temperature adjusting dial
(active in manual mode
V1 Heating light.

2) Remote control mode

Set the cursor to .
You can control the heater with the remote control in this position.
Stand in front of the heater and direct the remote control towards the infrared cell
Note: during installation remove the protective film from the infrared cell to ensure better use of the remote control.
Horizontal Model
3
6 6 6 6 6
USING THE PANEL HEATER
)
8 8 8 8 8
6 6 6 6 6
.
6 6 6 6 6
bis.
V1
8 8 8 8 8
.
Hight Model
6 6 6 6 6
bis
7 7 7 7 7