Zanussi ZBB28460SA Notice D'utilisation page 13

Remove the correct
part from the hinge
cover (E). Make sure
to remove the part
DX, in the case of
right hinge, SX in op-
posite case.
~50 mm
o
90
21 mm
o
90
~50 mm
21 mm
Install the part (Ha) on
the inner side of the
kitchen furniture.
www.zanussi.com
C
D
E
E
B
Attach the covers (C,
D) to the lugs and the
hinge holes.
Install the vent grille
(B).
Attach the hinge cov-
ers (E) to the hinge.
Ha
Hc
Push the part (Hc) on
the part (Ha).
G H
Connect the appli-
ance laterally to the
kitchen furniture side-
wall:
1. Loosen the
screws of the
part (G) and
move the part (G)
till the furniture
sidewall.
2. Tighten the
screws of the
part (G) again.
3. Attach the part
(H) to the part
(G).
8 mm
Hb
Ha
Open the appliance
door and the kitchen
furniture door at an
angle of 90°.
Insert the small
square (Hb) into
guide (Ha).
Put together the ap-
pliance door and the
furniture door and
mark the holes.
Ha Hb
Hc Hd
Disconnect the parts
(Ha), (Hb), (Hc) and
(Hd).
8 mm
K
Ha
Remove the brackets
and mark a distance
of 8 mm from the out-
er edge of the door
where the nail must
be fitted (K).
13