Zanussi ZBB28460SA Notice D'utilisation page 11

Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power supply
socket is not earthed, connect the appliance
to a separate earth in compliance with current
regulations, consulting a qualified electrician.
• Loosen the upper
pin and remove the
spacer.
• Remove the upper
pin and the upper
door.
Ventilation requirements
The airflow behind
the appliance must
be sufficient.
www.zanussi.com
• Loosen the middle
hinge.
5 cm
min. 200cm
2
min.
200cm
2
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Door reversibility
The door of the appliance opens to the right. If
you want to open the door to the left, do these
steps before you install the appliance:
• Remove the lower
door.
• Loosen the lower
pin.
Installing the appliance
Caution! Make sure that the mains cable
can move freely.
Do the following steps:
On the opposite side:
• Install the lower pin.
• Install the lower
door.
• Tighten the middle
hinge.
• Install the upper
door.
• Tighten the spacer
and tighten the up-
per pin.
11