Insertion Of Battery (Fig. 1); To Remove Battery Pack; Battery Capacity Indicatorn (Fig. 2); Assembly - VARO Powerplus POWDPG7561 Utilisation Et Entretien

NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
8.2

Insertion of battery (Fig. 1)

WARNING Always remove battery pack (12) and key (2) from your tool when
you are assembling parts, making adjustments, cleaning, or when not in use.
Removing battery pack and key will prevent accidental starting that could
cause serious personal injury.
▪
Raise the battery cover (7).
▪
Place the battery pack (12) in the mower.
▪ Align raised ribs on battery pack with grooves in the mower's battery port.
▪
Push down into battery compartment until the battery clicks into place.
▪
Lower the battery cover.
WARNING Make sure the latch on the top of the battery pack snaps in place
and the battery pack is fully seated and secure in the mower's battery port
before beginning operation. Failure to securely seat the battery pack could
cause the battery pack to fall out, resulting in serious personal injury.
8.3

To remove battery pack

▪
Raise the battery cover.
▪
Press and hold the battery latch button at the top of the battery pack.
▪
Remove battery pack from the mower
WARNING To avoid serious personal injury, always remove the battery pack
and key when carrying or transporting the tool.
8.4

Battery capacity indicatorn (Fig. 2)

There are battery capacity indicators (15) on the battery pack, you can check the capacity status
of the battery if you squeeze the button (16). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
▪ 3 LED's are litt: Battery fully charged
▪ 2 LED's are litt: Battery 60% charged
▪
1 LED is litt: Battery almost discharged

9 ASSEMBLY

9.1

Unfolding and adjusting handle assembly (Fig. 3)

9.1.1

To raise handle assembly

▪
Open the lower handle locks (5).
▪
Pull up and back on the lower handle (8) until it is aligned with the slot between the handle
locks and the mower housing.
NOTE: If the lower handle is difficult to move, turn the lower handle locks (5)
counterclockwise to free the handle.
Copyright © 2020 VARO
POWDPG7561
P a g e | 9
EN
www.varo.com