Product Operation - brondell P700BB Manuel D'utilisation

OPERATION

Product Operation

Place the air purifier on a flat, solid surface. Do not block the Air Outlet with
objects, and remove any heat sources and/or open flames near the unit.
Turning the Brondell Pro Sanitizing Air
Purifier On
1. Insert the power cord into the power cord
port on the back of the unit and plug the
unit into the nearest power outlet.
2. Touch the red blinking Power
button on the top of the control
panel to turn the unit on. The unit
will chime and the control panel
will illuminate.
The unit will start in Auto Mode and begin to
sense the air quality in the room. Once the
air quality has been determined, the PM2.5
value will display on the control panel and
the unit will regulate to an appropriate fan
speed.
The airflow is adjusted according to PM2.5.
Auto Mode is set as follows:
Air
PM2.5
Quality
Value
Level
10-79 Good
80-199 Fair
200-500 Bad
3. To turn the Brondell Pro Sanitizing Air
Purifier off, press the Power button.
The unit will chime and power off.
10
Air
Quality Airflow
Light Level
Color
Green 1
Blue 2
Red 3
Selecting the Operating Mode
Air Speed – Touch the Speed
button to toggle between 3 fan
speeds: P1 (LOW), P2 (MEDIUM),
and P3 (HIGH). Touch the Speed
button a fourth time for Auto
Mode (P0).
Sleep Mode – Touch the Sleep
button to enter Sleep Mode.
Fan speed will power down to
the lowest level, the air quality
indicator light will turn off, and all
lights on the control panel will turn off
except for the Sleep button. Touch the
Sleep button again to disengage
Sleep Mode.
UV – Touch the UV button to
activate UV sanitization. The UV
light inside the machine will turn
on. To turn off UV sanitization,
touch the UV icon.
Plasma – Touch the Plasma
button to initiate the unique
Plasma generation. The unit will
emit positive and negative ions
into the air, creating enough
energy to disturb bonds and destroy
microorganisms. These negative ions will
remove smoke, dust, and odors from the air
while improving air quality and health.