Manual Over-Ride - Eaton 706rEUR-00 Mode D'emploi

Capteur de perte de verticalité. il peut aussi être utilisé comme émetteur panique, et ce jusqu'à une distance maximale de 900 mètres d'un récepteur scantronic.
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
Tilt Switch
If the 706r is in Tilt Switch - Buzzer mode then the buzzer starts a warning tone
approximately 5 seconds after the unit tilts more than 45 degrees from vertical. The
warning tone lasts for 15 seconds while the unit is tilted. At the end of the warning tone
the unit sends an alarm signal to the receiver if it is still tilted. Restore the unit upright to
silence the warning tone.
Tilt Switch - Silent mode operates in a similar way to Tilt Switch - Buzzer mode, but the unit
does not give any warning tones.

Manual Over-Ride

If you wish to work for a short time with the 706r tilted past 45 degrees, then press the grey
button on top of the unit to temporarily disable the tilt switch. After you press the button the
unit ignores the tilt switch for 5 minutes. Press the grey button again for another delay.
This facility lets you work without causing false alarms by inadvertently tilting the 706r.
Servicing
The 706r does not contain any serviceable parts. The unit should be replaced within one
month of signaling "Low Battery"
12

Publicité

Table des Matières
loading

Table des Matières