RIESE & MULLER Roadster 2022 Traduction De La Notice Originale page 34

English
Seals
•
Bearings
•
Gear cables
•
Brake pads
•
Rims or brake discs
•
Handles
•
Sprockets, pinions or toothed belt discs
•
Tires
•
Saddle cover
•
Elastic luggage straps
•
Pedal surfaces
•
Stand caps
•
Check the condition of the above wear parts regularly and, if necessary, have them
replaced by your dealer.
The brake pads in rim or disc brakes are subject to wear owing to their function. If the E-
Bike is used for sports purposes or for riding in mountainous terrain, it may be necessary
to change the brake pads more frequently.
Replacing these parts due to wear is not subject to the statutory liability for defects.
The bearings and seals for suspension forks and spring-loaded rear stays are in constant
motion when the chassis is working. The joints, bearings and components of the steering
system as well as hubs and pedals also move. Environmental factors cause wear on these
moving parts. These areas must be regularly cleaned and maintained. Depending on the
conditions of use, it cannot be ruled out that parts may need to be replaced due to wear.
Failure to comply with the assembly specifications and inspection intervals can void the
warranty and liability for defects. Please observe the checks and inspections outlined in
your manual.
According to the European Approval Regulation (EU) No 168/2013, the durability for an
E-Bike of vehicle class L1e-B is 16,500 km.
In accordance with its high quality standards, Riese & Müller estimates a product service
life of 33,000 km for all of its E-Bikes. However, the strain on an E-Bike depends heavily on
the load, the condition of roads and the riding style.
The main influencing factor is the rider's weight. Please see the diagram below for the
relevant service life of your E-Bike:
34
Inspections and service life