RIESE & MULLER Roadster 2022 Traduction De La Notice Originale page 18

English
Design of the Q-Loc quick-release axle
The quick-release axle consists of two firmly connected components, the hand lever A and
the nut B. The hand lever A creates a clamping force and the nut B sets the preload.
Handling the Q-Loc quick-release axle
1. Open: Flip hand lever A so that it reads "Open" on the inner side. To release further,
press nut B towards hand lever A and turn it clockwise until the claw is locked. Then
pull the quick-release axle out by hand lever A.
2. Close: Turn the nut B anticlockwise until the claw is released from the lock. With the
claw open, push the quick-release axle through the fork and hub until it engages with
an audible click. Using the ball of your hand, flip the hand lever A so that you can read
"Close" on the outer side.
3. Check: Check the quick-release axle is secure by trying to turn the closed hand lever A.
If the hand lever A can be turned in a circle, the wheel is not sufficiently secured. In this
case, open the hand lever A and increase the preload on the nut B.
18
Components: function and handling