Operation - Greenlee 555C Mode D'emploi

Operation

Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Pinch points:
Keep hands away from bending shoe,
rollers and conduit when bender is in
use.
Failure to observe this warning could
result in severe injury or death.
Do not operate the bender while wearing loose cloth-
ing. Loose clothing can get caught in moving parts.
Failure to observe this warning could result in severe
injury or death.
RETRACTING 1-1/2" AND 2" ROLLER UNITS
Note: The 02544 EMT bridge unit and 01323 IMC/rigid
bridge unit have a spring to properly engage the 1-1/2"
and 2" roller units when the loading pedal is depressed.
Before loading conduit or rotating the shoe hook past
the rollers, check that the 1-1/2" and 2" roller units are in
the fully retracted position as shown.
Greenlee Tools, Inc.
To fully retract the rollers, depress the loading pedal
until the arm contacts the stop and remove your foot
from the loading pedal. The 1-1/2" and 2" roller units
should drop into the fully retracted position. If not, use
one hand to slightly press the loading pedal, and use a
tool (e.g., screwdriver) to adjust the roller so that both
rollers rotate counterclockwise to the retracted posi-
tion. Using a tool to adjust the roller will keep hands and
fingers clear from any potential pinch points.
1-1/2" and 2"
roller units
shown in the
fully retracted
position.
11
555C Electric Bender Classic
Depress loading pedal.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
1-1/2" and 2"
roller units
not fully retracted.
Use a tool (e.g., screwdriver)
to rotate 1-1/2" roller unit
counterclockwise and then
release loading pedal.