Preparing The Appliance - Krups EA 80 Serie Utilisation Et Entretien

KRUPS Espresseria Automatic

3.2 Preparing the appliance

Before switching on the appliance, carry
out the following steps.
Caution : Water tank (14): Do not
!
fill the tank with hot water, mineral water,
milk or any other liquid as this could da-
mage the appliance.
Coffee bean holder (19): Do not put
ground coffee or water into the coffee
bean holder as the grinder could be da-
☞ Remove the water tank (14) and fill it with
cold water.
i
Tip : You can fill the tank without removing it:
open the lid and pour in the water using a sui-
table recipient.
☞ Fit it and close the lid.
☞ Open the lid (16) of the coffee bean hol-
der (19) and fill it with coffee beans (max.
275 g).
☞ Close the lid of the coffee bean holder.
14 Use and maintenance / SERIE EA 80xx
maged. Ensure that no foreign particles
(e.g. small stones in the coffee beans)
get into the holder as they could damage
the grinder (not covered by the guaran-
tee!).
Drip tray (27): To avoid the risk of burns
due to hot water splashing, check that
the drip tray is fitted correctly!
!
Important: Respect the maximum filling
level (reference "Max") of the water tank.
!
Note : If, when the appliance is switched
on, the water tank is missing or does not
contain enough water (under the refe-
rence "Calc"), the message "Fill the tank"
will be displayed and it will not be possi-
ble to prepare espresso or coffee.