Operation And Features - RealFlame 1330E Guide D'utilisation

CONTROL PANEL OPERATION
After reading all the instructions, confirm that all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. The control panel is located at the
top right of your fireplace.
MAIN POWER
POWER (Standby)
Push this button to turn
the unit on. Push it again
to enter stand-by mode.
Note: When the O/I switch is turned OFF, all other fireplace functions will stop.
!
NOTE
When turned to standby the embers of the flame will not immediately go out.
This is a designed feature to represent the embers of the fire slowly fading out.
!
NOTE
Although the heater has been turned off the fan may still run to prevent
over-heating.
TECHNICAL SPECIFICATION Supply: 120V~60Hz. Rated Power: 1400W

OPERATION AND FEATURES

Press the O/I button for main power.
FLAME COLOR
Changes the color of
the flame.
12
ON
OFF
HEAT SETTING
Press this button
once for the low
heat setting (700W);
press twice for the
high heat setting
(1400W); press again
to turn off the heater.