Atlantis A02-RA3+ Guide Rapide page 52

ENGLISH
Click on AUTO SCAN (and then on Start) in order to obtain the
information on the type of protocol and the values of VCI/VPI (if a
connection exists already, cancels it going in Configuration-
WAN-ISP and pressing delete). In case you know already these
values you will be able to proceed immediately inserting them,
passing to the opportune section. After to have pressed key
AUTO SCAN you obtain the characteristic parameters of your
line ADSL.
Select now (in case of multiple choice) the configuration and then
press on Apply. Now you need only to insert the remaining
parameters (Username and Password in the case of PPPoA/PPPoE
or IP/Subnet/Default address Gateway in the RFC1483/1577 case).
Finished the configuration press on Save Config to FLASH (and
then on Save) to save settings.
52