Porter Cable FR350A Manuel D'instructions page 9

Never load nails with the contact trip or trigger activated. Personal injury
may result.
DO NOT load fasteners strip into magazine backwards.
1. Read all Safety Warnings before using tool.
2. Connect the tool to air supply.
note: See icon (K) for fastener direction.
3. Insert fasteners (L) into T-slot (J) at the rear of the magazine (E) past the nail follower
(E). note: Magazine will hold two full fastener strip.
fig. 2
D
4. Depress pusher release (H) and pull pusher (I) back until the nail follower (E) falls
behind the fasteners.
fig. 4
note: Do not allow the pusher to snap forward against the nail strip, allowing this to
happen could damage the nail collation.
note: This tool has a dry fire lock out device which will not allow the tool to fire when
the fastener quantity in the magazine is reduced to four. When unloading and loading the
magazine always make sure these four nails have been removed from the magazine. If
the nails are not removed from the magazine and the tool is reloaded and fired the nails
will cause the tool to jam.
actuatInG tool
To reduce the risk of injury, ALWAYS wear proper eye [ANSI Z87.1 (CAN/
CSA Z94.3)] and hearing protection [ANSI S12.6 (S3.19)] when operating this tool.
The tool can be actuated using one of two modes: single sequential action trigger mode
and bump action trigger mode.
l
J
K
H
9 - ENG
Fig. 3
l
Fig. 5
l
e
I