Fein Turbo I Mode D'emploi page 8

en
8
Extension cable.
If the use of an extension
WARNING
cable is required, its length
and conductor cross-section must be ade-
quate for the applicational case, in order to
prevent a voltage drop in the extension cable,
power loss and overheating of the vacuum
cleaner. Otherwise, the extension cable and
vacuum cleaner are liable to electrical danger,
and the working efficiency will be impaired.
Intended use of the vacuum cleaner:
Wet/dry vacuum cleaner for vacuuming and
extraction of dry, non-hazardous dusts and
dusts of dust category L, minor dust particles,
particularly when carrying out dust-forming
work with a power tool, and non-combusti-
ble liquids, in weather-protected environ-
ments using the application tools and
accessories recommended by FEIN.
Operation of the power tool off power generators.
This vacuum cleaner is also suitable for use
with AC generators with sufficient power
output that correspond to the Standard
ISO 8528, design type G2. This Standard is
particularly not complied with when the so-
called distortion factor exceeds 10 %. When
in doubt, please refer to the generator
instruction/specification guide.
Recommended dimensions of extension cords
at an operating voltage of 120 V – single-
phase a. c., with only Turbo I, Turbo II,
Turbo II S2106 connected:
Max. cable length, ft
≤ 100 100 200
–200 –300
Min. conductor size
A.W.G.
16 14
WARNING
The vacuum cleaner contains dust
hazardous to one's health. Have the
emptying and maintenance, incl. the disposal
of dust-collection containers, carried out only
by specialists. Appropriate protective equip-
ment is required. Do not operate the vacuum
cleaner without the complete filter system.
Otherwise there is danger to your own
health.
Operating the vacuum cleaner
WARNING
off power generators whose
no-load voltage exceeds the voltage value on
the type plate of the power tool is prohibited.
Max. cable length, m
≤ 30 30
– 60
Min. conductorcross-
2
section, mm
12 1.5 2.5
60
–100
4